Ideas Lab | Allow Global Edit of out of bank Roughness

You need to login before you can vote.

If you are not registered on the site, register here.

3	Allow Global Edit of out of bank Roughness Published on 13/01/2010 at 15:09 by Conor Galvin Could there be an addition to the global edit function which would allow both the in-bank and out-bank roughness to be defined?

top

1 comment

» Comment by Richard_Measures on 15/04/2010 at 16:17

I might be missing the point here but can we not do this already by ticking the "where value equals" check box when performing a global edit so as to select only out of bank or in bank roughness (assuming they were assigned different roughness values originally).

top